-

Series 3000 - Brass Fittings for Black Low Density and High Density Polyethylene Pipe, with Plastic Seal and Patented Mounting System

-

 

High & Low Density Polyethylene Pipe Fittings in according to Standard UNI EN 1254-3:2000 and produced in UNI EN 12165 CW617N hot forged brass. The hydraulic-keep is guaranteed by a NBR 70 Sh. O-Ring [ A ] while the mechanical seal is guaranteed by an a plastic elastic gear [ B ]. This system patented by RINALDI & PETTINAROLI® can provide an immediate pipe retention during insertion, combined with a perfect hydraulic-keep. For the correct usage is only necessary unscrew the cap and insert the pipe until the end of hole, replace the cap by hand ; confirm the tightening with a common tool.

Art. 3000
Art. 3000
Male Fitting
Art. 3001
Art. 3001
Female Fitting
Art. 3002
Art. 3002
Socket
Art. 3003
Art. 3003
Elbow 90°
Art. 3004
Art. 3004
Female Elbow
Art. 3005
Art. 3005
Male Elbow
Art. 3006
Art. 3006
TEE
Art. 3007
Art. 3007
Female TEE
Art. 3009
Art. 3009
Female Wallplate Elbow
Art.3018
Art. 3018
Reinforcement Insert for PE Pipe